Todd Sumamno
Skirting boards, often known as baseboards, go along the bottom portion of an interior wall. Typically, they hide the gap between the floor and the wall. They are commonly constructed of wood, although they may also be made of MDF, plastics, and vinyl.
In general, skirting boards should be put after the flooring has been set to guarantee a nice finish, unless the floor is to be carpeted, in which case skirting boards should be installed first to allow the carpet to be fitted to a clean, straight edge. Fitting a skirting board is a relatively simple operation if you have the necessary tools and are a moderately experienced DIYer.
Installation Techniques for Skirting Boards
Skirting boards come in a wide range of styles and sizes. The most frequent materials used are wood, MDF, and plaster. The method for installing skirting boards is determined by the type of skirting you select. The following are the three primary forms of skirting board installation:
Sculpted Skirting Boards
These are common in older homes and might be difficult to locate a replacement for nowadays. If matching the skirting proves problematic, consider attaching a molded architrave to the top of a square-edged board. This will prevent you from replacing all of the skirting boards, such as MDF Skirting World on your property.
Skirting Pre-Finished Boards
Pre-finished skirting boards are simple to install because they don’t need to be sanded or painted. These are suitable for floor covering, do not warp, come in great lengths, are quite robust, and have very consistent colors.
Removable Skirting Boards
If you’re concerned that putting skirting boards would prevent you from accessing your wall cavities, this newer form of the skirting allows you to do so. You can check for termites and discover infestations that might otherwise go undetected.
Installing Skirting Boards
Determine the Length of The Wall
Make sure you write down your skirting board measurements precisely. Calculate the lengths of your skirting boards using the tape measure. Apply this measurement to the border boards. With the handsaw, cut a straight line through the skirting board.
Trim the Skirting Board to Size
After marking the skirting board, cut it at a 45-degree angle with the meter box and handsaw. This is the first piece of skirting that will be cut to match the board’s profile.
Cut Along the Scribed Line
Cutting ascribed joint ensures that one end of the skirting board matches the profile of the other, resulting in a smooth corner join. Follow the 45-degree cut you just made in the skirting board with the coping saw. As the line changes, cut in and out with the coping saw. Cutaway from the skirting board as you approach closer to the top.
Trim the Skirting Boards to Size and Attach Them in Place
For the first skirting board, measure the length of the wall. Then, trim the board with a 90-degree cut on both ends. To discover the wooden frames behind the wall, use a stud finder. Use the nail gun to secure the skirting board to the wall and flush with the corner. Cut the scribed joint skirting board to size, then push it against the first skirting board, such as MDF Skirting World, to make it flush. Ten use the nail gun to fasten it. Rep until all of the skirting boards has been fitted.
Brittany
